Hello to everybody. First of all I would like to apologize for not writing in German, but my German isn't so good in order to describe my problem.

I would like to program a KNX installation from my PC that is located far from it. I followed the instructions given by (http://www.weinzierl.de/download/pro..._Remote_EN.pdf). I have the following SIEMENS devices: N146/01, N148 IP, N350E. I tried the first solution that is described on the pdf, but the only thing that I was able to do, was to send telegrams to my group addresses. I wasn't able to program any device on the installation. I used both ETS3f and the ETS4.0.3 and tried with all the KNX/IP devices that I have.

Any idea?