Status led problem with Tastsensor 2 gira & DIMACTOR 4x210Watt Gira

[whatevr]

Dear,

I've problems with the status indication led of the sensor. When I switch (1bit) it works fine (on/off) when I dim the light (4bit/8 bit) the status indication never works. I would like to have when the ligt is dimmed that the status led is also on.

I though it was possible doing this via the feedback telegram of the dimmer, but it is not available for 4bit group addresses.

Tnx,

Tim

[Meudenbach]

I'm not realy shure but i think you have a 1-bit state objekt. In the properties you must set "send state value". Check the flag setting. The state objekt must have all flags enabled...

Use a different group adress for the state value and "connect it" with the objekt from the LED.

If you didn't have a state objekt you can do the same way with the switch objekt (Flags !!). Some Actors also support this way...

regards