PDA

Archiv verlassen und diese Seite im Standarddesign anzeigen : ETS3 verstellt die Herstellernummer im BCU



VS_befe
22.11.07, 13:50
Nach dem Umprogrammieren eines Siemens LOGO-KNX-Kopplers bringt die ETS3 plötzlich denn Fehler:"Gerät ist von einem anderen Hertseller".
Unter Gräteinfo wir die Herstellernummer 5633 angezeigt. Scheinbar wurde das Gerät beim umprogrammieren "abgeschossen".

Das selbe Problem hatte ich schon bei drei BCUs von Jung. Aber erst seit ich die ETS3 verwende.

Hat jemand ähnliche Probleme oder vielleicht eine Idee woher der Fehler kommt?

S. De Bruyne
22.11.07, 14:26
It would ne nice if the behaviour could be reproduced. This will of course not be possible as ETS will refuse a new download because of the incompatible manufacturer code between device and application.

I assume it is best you contact the manufacturer about this problem. Possibly, it is known that certain circumstances lead to this behaviour. ETS will of course never intentionally change the manufacturer code. From KNX support, it is now rather difficult to help, I guess. You need to contact the manufacturer anyhow to check how you can correct the manufacturer code again.