6987/10 Problems

[mhugo]

Hello!

Im trying to add a 6987/10 powernet coupler to my TP network.

I can talk to the gatway, but not the powernet buscouplers.

I get timeouts.

Any suggestions?

[GLT]

Hello!

Im trying to add a 6987/10 powernet coupler to my TP network.

I can talk to the gatway, but not the powernet buscouplers.

I get timeouts.

Any suggestions?
Hello!
Which application you loaded in the device? Without application the device works as a repeater.

Are you using the right system-id?

Please notice that buscouplers-mask-version higher than 10.13 needed for media overspanning functions.

[mhugo]

Sorry for my long pause in the topic :)

It doesent find the devices when I try to program them. It found one and its identical to ten other units im trying to include.

Im running on system id 116.

[mhugo]

Manufacturer: Busch-Jaeger Elektro
Application program: Medien-/Bereichskoppler/2
Device type: $6983
Program version: 1.1
Certification status: registered

[mhugo]

General
Mask version 7.1 PL

Individual Address 0.2.0

Domain Address 76

Device manufacturer Busch-Jaeger Elektro

Programming mode Off

Re Config Repeater present, Is repeater

Application Program
Program Medien-/Bereichskoppler/2

Device Type $6983

Version 1.1

[Klaus Gütter]

Obviously the media coupler has the wrong domain address (76 instead of 116).

Make sure the domain address is set correctly in ETS (properties of the line - is this really line 0.2?), then program the coupler's address again.

Regards, Klaus Gütter

[mhugo]

Sorry - was mixing with it today.

Im trying to program the units via a TP rs 232 coupler, but only one works.

/MH

[Klaus Gütter]

What exactly fails? Programming the individual address? Or the application program? Could you please post the exact error message (with "Details" if available).

Klaus Gütter

[EIB-Freak]

Ich erhalte "Domain adress read failed" beim Versuch, mit der ETS3f dem Medienkoppler eine Phys. Adresse zu programmieren (egal ob per USB, IP oder sonstwie an KNX/TP angeschlossen).