iJAF
05.11.10, 11:42
Hi, sorry for my post in english !!
I have 3 Presence Detectors 5WG1 258-2AB21, to control 3 light circuits with Motion an Light restrictions !
The Presence Detection works fine (turn on and off the circuits with the time i have defined) !!
But I want to turn on ONLY if there isn't enough light (and presence obviously) !
No matter the Brightness value I select in the Presence Detector parameters (minimum-1 or maximum-8) , the 3 light circuits always turn on and off, even if the ambient is dark enough !!!
Is there any known problem with the Brightness Sensors in the the Presence Detectors ?!
I have attached the printscreens of the sensor configuration in ETS project if it could be useful !
Thank you :Prost:
I have 3 Presence Detectors 5WG1 258-2AB21, to control 3 light circuits with Motion an Light restrictions !
The Presence Detection works fine (turn on and off the circuits with the time i have defined) !!
But I want to turn on ONLY if there isn't enough light (and presence obviously) !
No matter the Brightness value I select in the Presence Detector parameters (minimum-1 or maximum-8) , the 3 light circuits always turn on and off, even if the ambient is dark enough !!!
Is there any known problem with the Brightness Sensors in the the Presence Detectors ?!
I have attached the printscreens of the sensor configuration in ETS project if it could be useful !
Thank you :Prost: